Something funky happened during today’s workout “Cadence Drills”, where the target power and resistance were intermittently not working correctly. The issue seemed to be predominantly on power levels of 80 watts or more.
Devices were connected and it was in ERG mode, but it was tough for the resistance to get high enough to produce higher target wattages.
It was working normally during warm-up, but then immediately after one of the first cadence increase efforts, the resistance faltered. The only thing I can think of is that I over spun it and whacked out the calibration? Or is it possible that because I did the full frontal the training effort adjustments aren’t happening automatically?
Here’s a few screenshots showing it doing okay at some points, but not others. I did check to make sure I didn’t have a flat tire and the roller resistance is set. Thanks for any advice !